If you do assembly of small quantities of cables.

If you have wasted time locating wires in a bundle, using a
meter or buzzer.

If you had to touch say, all 50 wires in a 50 wire bundle before finding the wire you were looking for.

WE HAVE THE SOLUTION FOR YOU!

Just follow these simple directions:

	With the HANDITRACE connected to the operator through the wrist band, connect the test lead to the desired contact of the pre-loaded connector.
	Separate the unterminated ends into two bundles and test each bundle for the tone by touching the bare ends.
	Separate the bundle that produces the tone into two smaller bundles and test each of these for the tone.
	Continue separating the tone-producing bundles into smaller bundles, testing for the tone until the desired wire is found.
	Terminate the wire and continue the process after moving the test lead on the pre-loaded connector to the next wire to be identified.
This tool is available to all Armed Services and Government Organizations under: NSN 6625-01-451-9374.